I have the router in the automatic address assigning mode, but the device is assigned an completely different address 10.0.1.72 than my PC 192.168.1.30. The firmware updating program states that the device needs to be on the same subnet as my PC. Each model includes two bisque colored faceplates for surface mounting or recessed-mount. For use with IntelliTouch control systems. Is the Pentair adaptor on the same subnet as my PC? pentair intelliconnect Product Description From the Manufacturer Adds to the ultimate in spa-side luxury with temperature display, thermostatic temperature control, and up to ten circuits. Probably a more productive effort is to figure out how the device is getting an IP address of 10.0.1.72 If the Orbi DHCP is assigning IP’s in the typical range of 192.168.1.x, the that IP address is not comiing from the Orbi. I was lookiing for the hardware specs and User Manual for the device. What’s the model number of the Pentair protocol adaptor? The ScreenLogic Plugin integrates HS4 with the Pentair ScreenLogic Protocol Adapter over a local area network. ScreenLogic is software: for computer and phone. The firmware updating program states that the device needs to be on the same subnet as my PC. You can perform a Pentair screenlogic protocol adapter reset by pressing the recessed reset button. I’m having trouble updating the firmware of a network attached device (Pentair Protocol Adaptor) with my new mesh network. If a second attempt to update fails, then contact Pentair Technical Support for more information. Likewise, people ask, how do I update my Pentair Easytouch firmware? The firmware version can be found on the label on the side of the protocol adapter. How do I update my Pentair easytouch firmware? When zone faults occur, it is often because the controller receives too much electricity from the irrigation system, causing the controller to shut down.

If the controller goes offline during a scheduled run, there may be an issue with the wiring or the irrigation system itself. How do I connect to Pentair ScreenLogic remotely? Why does my Rachio keep going offline?

The factory settings will be in assigned.Press and hold the four buttons simultaneously for about 4 seconds.Press the stop button – the pump will stop.